- Sizes - 5.82 oz.
- Mediums- Vellum, Embossed Vellum, Ribbon, Acetate, Cardstock, Paper. Refer to Helmar Adhesives Easy Selection Chart.
- Instructions:
- Ensure surface to be sprayed is clean and dry.
- Hold can at 45 degree angle, spray 8" to 10" from the surface to be sprayed using a side to side motion to ensure even application. A light and even spray is all that is needed
- Apply to reverse side of vellum, embossed vellum, ribbon, Paper & Cardstock, etc.
- Wait approximately five minutes for adhesive to become tacky and clear.
- Dry Time - Wait approximately five minutes for adhesive to become tacky and clear. V2 will remain tacky, so you can leave it ntil you are ready to apply, there is no hurry. V2 is initially repositionable so if you don't lay your vellum/ribbon/paper/etc. correctly the first time you can always lift it off and re-apply it.
- Acetate/Overlays: Mask off an area just smaller than your acetate/overlay on your cardstock. Apply per directions above. Wait approx. five minutes for adhesive to become tacky & clear. Place acetate onto treated area.
- Helmar Products are ACMI certified to ensure our products are the safest they can be.
- Clean up -IMPORTANT: After use, invert can and press nozzle to clean valve and nozzle.
- Where you can purchase it - List of Helmar Preferred Retailers on Blog: www.helmarusa.typepad.com (left side)
- Wholesale retailers contact - info@helmarusa.com
- Tips: Nice thin, even layer is key. Dries clear, and repositionable at first.
- Precautions - Always apply in an area away from your normal working area. Always use aerosol products in a well ventilated area. Sample is is always advisable. avoid breathing vapors, and contact with heat, sparks and open flame.
LIVE Product Spotlight with Tracy Weinzapfel featuring V2 Vellum Adhesive:
Helmar YouTube Video showing how to clean your Die Cutting Mats!
